Express 1/2 Ton Van V8-5.7L VIN R (1999)
Power Steering Line/Hose: Service and Repair
P/S Cooler Pipe/Hose Replacement
REMOVAL PROCEDURE
1. Make preparations in order to catch any fluid that drains out of the connections.
2. Disconnect the power steering hose (3, 4) connections.
3. Cap the power steering hoses and cooler ends in order to prevent the entry of dirt.
4. Disconnect the power steering pipe connections.
5. Cap the power steering pipes and cooler ends in order to prevent the entry of dirt.
6. Remove the nuts (2).
7. Remove the cooler (6) from the vehicle.
INSTALLATION PROCEDURE
1. Install the cooler (6) to the vehicle.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the nuts (2).
-
Tighten the nuts to 28 Nm (21 ft. lbs.).
3. Connect the power steering hose (3, 4) connections.
4. Connect the power steering pipe connections.
5. Fill the power steering system with power steering fluid.
6. Bleed the power steering system. Refer to Bleeding Power Steering System.
Power Brake Booster Inlet Hose Replacement
REMOVAL PROCEDURE
1. Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
