Express 1/2 Ton Van V8-5.7L VIN R (1999)
5. Remove the hose from the vehicle.
INSTALLATION PROCEDURE
NOTICE: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
1. Route the hose in the same position the hose occupied prior to removal.
2. Smoothly route the hose in order to avoid sharp bends and kinking.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the steering gear inlet hose (1) to the steering gear (2).
-
Tighten the hose fitting to 27 Nm (20 ft. lbs.).
4. Install the power steering inlet hose (2) to the steering pump (1).
-
Tighten the hose fitting to 27 Nm (20 ft. lbs.).
5. Check the power steering fluid level. Refer to Checking and Adding Power Steering Fluid.
6. Remove the drain pan from under the vehicle.
7. Bleed the power steering system. Refer to Bleeding Power Steering System.
Power Steering Gear Pipe/Hose Replacement - Outlet
REMOVAL PROCEDURE
1. Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
