Express 1/2 Ton Van V8-5.7L VIN R (1999)
Ball Joint: Service and Repair
Lower Ball Joint
REMOVAL PROCEDURE
-
Tools Required
-
J 9519-E Ball Joint Remover/ Installer Set
-
J 23742 Ball Joint Separator
1. Raise the vehicle. Support the vehicle with suitable safety stands.
2. Remove the tire and wheel assembly.
CAUTION: Floor jack must remain under the lower control arm during removal and installation to retain the lower control arm in position.
Failure to do so could result in personal injury.
3. Place a floor jack under the lower control arm. Raise the jack in order to support the control arm.
NOTICE: Support the caliper with a piece of wire to prevent damage to the brake line.
4. Remove the front brake caliper.
5. Remove the cotter pin and the nut from the lower ball joint.
