Express 1/2 Ton Van V8-5.7L VIN R (1999)
4. Install the rear propeller shaft (3). Line up the reference marks.
5. Slide the front end of the shaft onto the splines of the front shaft. Slide the front end of the shaft far enough forward in order to allow the rear
universal joint to engage the pinion flange.
6. Seat the rear universal joint into the axle pinion flange.
7. Install the retainers (1).
8. Install the bolts.
^
Tighten the center bearing retaining bolts to 20 Nm (15 ft. lbs.).
9. Remove the safety stands and lower the vehicle.
