Express 1/2 Ton Van V8-5.7L VIN R (1999)
Axle Shaft Assembly: Service and Repair
10.5 Inch Axle
REAR AXLE SHAFT
Removal Procedure
1. Raise the vehicle on a hoist and support with safety stands.
2. Remove the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation (Excessively Tight Wheels) in Wheels, Tires and
Alignment.
3. Remove the axle shaft bolts (6) from the axle shaft (5).
4. Remove the axle shaft (5) from the axle carrier.
5. Remove the axle shaft gasket (4).
Installation Procedure
1. Install a new axle shaft gasket (4).
2. Install the axle shaft (5) to the axle carrier.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the axle shaft bolts (6) to the axle shaft (5).
^
Tighten the axle shaft bolts to 156 Nm (115 ft. lbs.).
4. Fill the axle with fluid. Refer to Lubrication Specifications.
5. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation (Excessively Tight Wheels) in Wheels, Tires and
Alignment.
6. Remove the safety stands.
7. Lower the vehicle.
