Express 1/2 Ton Van V8-5.7L VIN R (1999)
Wheel Bearing: Service and Repair
FRONT WHEEL BEARING/HUB
REMOVAL PROCEDURE
1. Raise the vehicle. Support the vehicle with safety stands.
2. Remove the wheel and tire assembly.
NOTICE: Support the caliper with a piece of wire to prevent damage to the brake line.
3. Remove the front brake caliper.
4. Remove the dust cap from the hub/rotor.
5. Remove the cotter pin.
6. Remove the nut and washer.
IMPORTANT: Do not damage the outer bearing and the spindle threads.
7. Remove the rotor from the spindle.
8. Remove the outer bearing.
9. Remove the dust seal. Pry the seal out and discard the seal.
10. Remove the inner bearing.
NOTICE: Do not spin the wheel bearings with compressed air to dry them-the wheel bearings may be damaged.
11. Clean all of the parts in a solvent, then air dry.
12. Make sure all of the parts are clean and free of grease.
13. Inspect the rotor.
14. Inspect the bearings and the races for wear or damage. Replace the parts as necessary.
INSTALLATION PROCEDURE
