Express 1500 RWD V6-4.3L VIN X (2005)
INSTALLATION PROCEDURE
1. Install the air temperature actuator.
2. Install the retaining screws to the air temperature actuator.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.9 N.m (17 lb in).
3. Connect the air temperature electrical connector to the actuator.
4. Install the left rear quarter trim panel.
Defroster Actuator
DEFROSTER ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the I/P upper trim pad.
2. Disconnect the vacuum hose (1) from the defrost actuator (2).
3. Depress the clip and remove the defrost actuator (2) from the heater assembly.
INSTALLATION PROCEDURE
1. Install the defrost actuator (2) to the heater assembly.
2. Connect the vacuum hose (1) to the defrost actuator (2).
3. Install the I/P upper trim pad.
Mode Actuator - Lower
MODE ACTUATOR REPLACEMENT - LOWER
REMOVAL PROCEDURE
1. Remove the I/P carrier.
