Express 2500 V6-4.3L VIN X (2005)
14. Remove the driven gear from the distributor shaft.
15. Remove the round washer.
16. Remove the tang washer.
17. Remove the shim washer (1).
18. Remove the old oil seal.
ASSEMBLY PROCEDURE
1. Line up the square-cut hole in the vane wheel for the camshaft position (CMP) sensor.
IMPORTANT: Installing the driven gear 180 degrees out of alignment, or locating the rotor in the wrong holes, will cause a no-start condition.
Premature engine wear or damage may result.
2. Insert the sensor into the housing.
3. Install two new screws for the camshaft position (CMP) sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2.2 N.m (20 lb in).