Express 2500 V8-6.6L DSL Turbo (2010)
Hood Latch Release Cable: Service and Repair
Hood Primary Latch Release Cable Replacement
Removal Procedure
1. Raise and support the hood.
2. Remove the cable (1) from the hood latch (3).
3. Remove the cable (1) from the retainer on the radiator support.
4. Push the cable (1) and the grommet into the cab from the engine compartment.
5. Remove the left side hinge pillar trim panel from the body. Refer to Body Hinge Pillar Trim Panel Replacement (See: Interior Moulding /
Trim/Trim Panel/Service and Repair/Body Hinge Pillar Trim Panel Replacement).
6. Remove the screws retaining the cable handle (3) to the body.
7. Remove the handle (3) from the body.
8. Remove the cable (1) from the vehicle.
Installation Procedure