Express 2500 V8-6.6L DSL Turbo (2010)
Note: If the rotor was removed using the jack screw method you must ensure that the hub flange is free of nicks or marks caused by this
procedure. Remove all raised nicks or marks before installing the rotor.
4. Align the rotor to its original position on the hub, if applicable, and install the rotor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Install the brake rotor screw and tighten to 12 Nm (106 lb in).
6. Install the brake caliper and brake caliper bracket.
7. Perform the following procedure before installing the brake caliper bracket mounting bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolts with brake parts cleaner or equivalent and allow to dry.
3. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolts.
8. Install the 2 brake caliper bracket mounting bolts and tighten to 175 Nm (129 lb ft).
