Express 2500 V8-6.6L DSL Turbo (2010)
9. Remove the transmission fluid fill tube upper nut and reposition the tube.
10. Remove the EGR heater inlet hose/pipe retainer stud at the rear of the engine.
11. Remove the EGR heater inlet hose/pipe retainer nut at the center of the lower right cylinder head.
12. Remove the injector wire harness stud at the center lower right cylinder head.
Caution: Label all the injector electrical connectors before the connectors are removed in order to prevent reconnecting to the wrong injector.
Failure to properly connect the injectors in the correct sequence will cause severe engine damage.
13. Disconnect the engine harness electrical connectors from the fuel injectors.
