Express 2500 V8-6.6L DSL Turbo (2010)
Caution: Ensure proper torquing of the fuel injector line. An under-torqued fuel injector line will not seal properly and an over-torqued fuel
injector line may damage the fuel injector fitting. An improperly sealed or damaged fuel injector line or fuel injector fitting will cause a fuel leak.
5. Install the fuel injector pipes and tighten to 41 Nm (30 lb ft).
6. After installing the fuel injector pipes, clean the injector pipes and apply sealant at the fittings to prevent moisture and debris from collecting
between the line and fitting. Refer to Adhesives, Fluids, Lubricants, and Sealers (See: Specifications/Adhesives, Fluids, Lubricants, and Sealers).
7. Position the engine wiring harness.
8. Position the main connector bracket to the generator bracket.
9. Install the main connector bracket bolts and tighten to 10 Nm (89 lb in).
10. Connect the right side main engine harness connector.
