Express 2500 V8-6.6L DSL Turbo (2010)
Crankshaft Main Bearing Seal: Service and Repair
VIN 6
Crankshaft Rear Oil Seal Replacement
Special Tools
*
J 44641 Crankshaft Rear Oil Seal Remover
*
J 44642 Crankshaft Rear Oil Seal Installer
Removal Procedure
1. Remove the engine flywheel. Refer to Engine Flywheel Replacement (See: Transmission and Drivetrain/Flex Plate/Service and Repair)
2. Install the button of J 44641 into the crankshaft.
3. Press the jaws of J 44641 into the felt portion of the seal far enough to engage the inner lip of the seal.
4. While holding the jaws of J 44641 tightly to the seals inner sleeve, tighten the jaw bolts.
5. Remove the crankshaft rear oil seal using the J 44641.
Installation Procedure