Express 2500 V8-6.6L DSL Turbo (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. From the left front wheel well, connect the power brake booster inlet hose (1) to the power steering pump (2). Tighten the hose fitting to 34 Nm
(25 lb ft).
5. Install the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
6. Lower the vehicle.
7. Tighten the power brake booster inlet hose fitting on the power brake booster to 34 Nm (25 lb ft).
8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Steering and Suspension/Steering/Power
Steering/Power Steering Bleeding/Service and Repair).
9. Clean any excess power steering fluid from the vehicle.
10. Remove the drain pans from under the vehicle.
VIN 6
Power Brake Booster Inlet Hose Replacement (Without LGH)
Removal Procedure
1. Place drain pans under the vehicle.
2. Remove as much power steering fluid from the reservoir as possible.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Vehicle Lifting/Service and Repair).
Caution: Refer to Power Steering Hose Disconnected Caution (See: Service Precautions).
4. From the left front wheel well, disconnect the power brake booster inlet hose (2) from the power steering pump (1).
5. Lower the vehicle.
