Express 2500 V8-6.6L DSL Turbo (2010)
5. Install the EN-47909-3 - brush to the EN-47909-1 - handle.
6. Insert the axial brush into the injector bore and rotate the handle while also applying a slight downward pressure, in order to force the brush ends
into the bottom corners of the injector bore.
Warning
Wear safety glasses in order to avoid eye damage.
7. Using compressed air, evacuate any debris from the injector bore.
Caution: Do not allow excessive amounts of solvent to go into the cylinder during cleaning. Failure to do so may cause engine damage upon
start-up.
8. Lightly dampen EN-47909-20 - swab with Top Engine Cleaner, GM P/N 1052626 (Canadian P/N 993026) or equivalent, and wipe away any
deposits from the injector bore.
9. Inspect the injector bore for any deposits and repeat brushing if necessary.
Warning
Keep hands and face clear of glow plug holes while cranking. Hot liquid or gases may be expelled during cranking.
Warning
Wear safety glasses in order to avoid eye damage.
10. If necessary, crank the engine in order to expel any solvent before starting the engine.
1. Remove the glow plugs. Refer to Glow Plug Replacement - Bank 1 (See: Glow Plug System/Glow Plug/Service and Repair/Glow Plug
Replacement - Bank 1) and/or Glow Plug Replacement - Bank 2 (See: Glow Plug System/Glow Plug/Service and Repair/Glow Plug
Replacement - Bank 2).
2. Disable the fuel system.
3. Disconnect the crankshaft position (CKP) sensor electrical connector.
4. Crank the engine in order to expel any excessive solvent.
5. Using the cotton swabs supplied with the kit, wipe the injector bore clean of any solvent and/or debris.
6. Connect the CKP sensor electrical connector.
7. Enable the fuel system.
8. Reinstall the glow plugs. Refer to Glow Plug Replacement - Bank 1 (See: Glow Plug System/Glow Plug/Service and Repair/Glow Plug
Replacement - Bank 1) and/or Glow Plug Replacement - Bank 2 (See: Glow Plug System/Glow Plug/Service and Repair/Glow Plug
Replacement - Bank 2).
Installation Procedure
