Express 2500 V8-6.6L DSL Turbo (2010)
Fuel Injector Replacement (Left)
Special Tools
*
EN-47909 Injector Bore and Sleeve Cleaning Kit
*
J-46594 Fuel Injector Puller
Removal Procedure
1. Remove the upper fan shroud. Refer to Engine Coolant Fan Upper Shroud Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L, 7.0L) (See: Engine,
Cooling and Exhaust/Cooling System/Fan Shroud/Service and Repair/Engine Coolant Fan Upper Shroud Replacement) Engine Coolant Fan Upper
Shroud Replacement (Diesel) (See: Engine, Cooling and Exhaust/Cooling System/Fan Shroud/Service and Repair/Engine Coolant Fan Upper
Shroud Replacement).
2. If equipped, remove the auxiliary generator. Refer to Auxiliary Generator Replacement (KD9) (See: Starting and Charging/Charging
System/Alternator/Service and Repair/Auxiliary Generator Replacement (KD9)).
3. Remove the glow plug module and bracket. Refer to Glow Plug Control Module Replacement (See: Glow Plug System/Glow Plug Control
Module/Service and Repair/Glow Plug Control Module Replacement).
4. Remove the injector/glow plug wire harness retaining bolt at lower upper valve cover.
5. Disconnect the left engine wiring harness connector.
6. Remove the engine wiring harness to bracket bolt, the 2 engine wiring harness bracket to upper valve cover bolts and remove the bracket (1).
