Express 2500 V8-6.6L DSL Turbo (2010)
Note: The crankshaft position sensor spacers are machined with different timing positions. However, if the crankshaft position sensor spacer
requires replacement, replace with a grade "C" spacer.
1. If necessary, lubricate a NEW CKP spacer O-ring with clean engine oil.
2. If necessary, install the NEW O-ring to the CKP sensor spacer.
3. If necessary, install the CKP sensor spacer.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. If necessary, install the CKP sensor spacer bolts and tighten to 10 Nm (89 lb in).
5. Install the CKP sensor.
6. Install the CKP sensor bolt and tighten to 10 Nm (89 lb in).
7. Connect the CKP sensor electrical connector.
8. Lower the vehicle.
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
