Express 2500 V8-6.6L DSL Turbo (2010)
4. Remove the IAT sensor from the center intake manifold.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the IAT sensor to the center intake manifold and tighten to 25 Nm (18 lb ft).
2. Connect the IAT sensor (2) electrical connector.
3. Install the air intake pipe. Refer to Air Intake Pipe Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance
Checks/Air Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair/Air Intake Pipe Replacement).
4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
