Express 2500 V8-6.6L DSL Turbo (2010)
5. If the steering gear has a female rack (5) and a male inner tie rod (1), apply LOCTITE(R) 262, or equivalent, to the threads on the right inner tie
rod.
6. Install the right inner tie rod to the rack.
7. Place a pipe wrench on the rack next to the left inner tie rod housing (4).
8. Place a torque wrench and the J-34028 - wrench on the flats of the steering linkage inner tie rod housing (7). Tighten the inner tie rod to 100 Nm
(74 lb ft).
9. Place each inner tie rod assembly (2) on a vise.
Note: If the steering gear has a female rack (1) and a male inner tie rod (2), do not stake. If the steering gear has a male rack and a female inner tie
rod, you must stake.
10. Stake both sides of the 2 female inner tie rod housings to the male rack.
11. Insert a 0.25 mm gauge (1) between the rack (2) and the inner tie rod housing in order to inspect the 4 stakes. The feeler gauge must not pass
between the rack and the inner tie rod housing stake.
