Express 2500 2WD V8-4.8L VIN V (2004)
6. Remove the brake caliper bracket mounting bolts (2).
7. Remove the brake caliper bracket (1).
8. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket.
9. Clean the mounting surface and threads of the brake caliper bracket.
Installation Procedure
1. Install the brake caliper bracket (1).
2. Perform the following procedure before installing the brake caliper bracket mounting bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
3. Notice:
Refer to Fastener Notice in Service Precautions.
Install the caliper bracket mounting bolts (2).
^
For vehicles equipped with JH5 brake systems, tighten the caliper bracket mounting bolts to 200 Nm (148 ft. lbs.).
^
For vehicles equipped with JH6/JH7 brake systems, tighten the caliper bracket mounting bolts to 165 Nm (123 ft. lbs.).
4. Install the anti-rattle clips to the brake caliper mounting bracket.
5. Install the brake pads to the brake caliper mounting bracket.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper.
8. Install the tire and wheel assembly.
9. Lower the vehicle.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
