Express 2500 2WD V8-4.8L VIN V (2004)
Engine Mount: Service and Repair
Engine Mount Replacement - Left
Engine Mount Replacement - Left
Removal Procedure
1. Notice: Refer to Engine Mounting Notice in Service Precautions.
Raise and support the vehicle.
2. Remove the tire and wheel.
3. Remove the front propeller shaft, 4WD vehicles only.
4. Remove the engine mount to the frame mounting bolts through the wheelwell.
5. Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking
against the oil pan may cause it to crack or break.
Important: Raise the engine only enough to permit removal of the engine mount.
Using a jack on the square tab at the rear of the engine block and raise the engine, left side shown.
6. Remove the front engine mount to the engine mounting bolts through the wheelwell.
7. Remove the rear engine mount to the engine mounting bolts from under the vehicle.
8. Remove the engine mount from the vehicle.
Installation Procedure