Express 2500 2WD V8-4.8L VIN V (2004)
1. Install the axle shaft bearing using the J23690, 8.6 inch axle, or the J45853, 9.75 inch axle (1) and the J8092 (2).
2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
3. For the 3.6 inch axle, install the axle shaft seal using the J21128.
Ensure the seal is fully seated in the axle tube.
4. For the 9.75 inch axle, install the axle shaft seal using the J45853 (2) and the J8092 (1).
Ensure the seal is fully seated in the axle tube.
5. Install the axle shaft.
6. Fill the rear axle.
7. Lower the vehicle.
