Express 2500 2WD V8-4.8L VIN V (2004)
2. Install the nut (1) which secures the crank arm to the wiper motor shaft.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Measure the gap between wiper motor crank arm and the bracket tab. If the gap is not 4-8 mm (0.157-0.314 in), remove the crank arm and repeat
installation.
Tighten
Tighten the wiper motor crank arm nut to 16 N.m (12 lb ft).
4. Install the wiper transmission on the wiper motor crank arm using the J 39529.
5. Install the wiper motor module assembly.
6. Install the air inlet grille panels (1,2).
7. Install the wiper arms.
