Express 3/4 Ton Van V8-305 5.0L VIN M SFI (1999)
^
Make sure that all of the parts are clean and free of grease.
^
Apply an approved high-temperature front wheel bearing grease to the spindle at the inner and outer bearing seat, the shoulder, and the seal seat.
^
Also, finger apply a small amount of grease inboard of each bearing cup in the hub/rotor.
^
Pressure pack the bearings with a grease machine, or hand pack the bearings. Make sure the grease is worked thoroughly into the rollers, the cone,
and the cage.
1. Install the inner bearing to the rotor.
2. Apply an additional quantity of grease outboard of the inner bearing.
3. Lubricate the seal lip.
3.1.
Install the seal.
3.2.
Use a flat plate in order to press the seal down flush with the hub.
IMPORTANT: Do not scuff the spindle threads.
4. Install the hub/rotor to the spindle.
5. Install the outer bearing to the hub/rotor.
NOTICE: Refer to Fastener Notice in Service Precautions.
6. Install the washer and nut.
IMPORTANT: Adjust the wheel bearings.
^
Tighten the nut to 16 Nm (12 ft. lbs.), while turning the wheel forward by hand.
7. Install the cotter pin.
8. Apply grease to the outboard side of the outer bearing.
9. Install the cap to the hub/rotor
10. Install the front brake caliper.
11. Install the tire and wheel assembly.
12. Remove the safety stands.
13. Lower the vehicle.
