Express 3/4 Ton Van V8-4.8L VIN V (2003)
6. Remove the 2 pan head tapping screws (1) and (3) from the turn signal and multifunction switch assembly (2).
7. Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly
Installation Procedure
1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.
2. Screw the 2 pan head tapping screws (1) and (3) into the turn signal and multifunction assembly (2).
-
Tighten the top pan head tapping screw (1) to 3 Nm (30 inch lbs.).
-
Tighten the side pan head tapping screw (3) to 7 Nm (62 inch lbs.).