Express 3/4 Ton Van V8-4.8L VIN V (2003)
6. Remove the mounting screws that fasten the EBCM (2) to the BPMV (1).
7. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
8. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
Installation Procedure
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
1. Install the EBCM (2) on to the BPMV (1).
Notice:
Refer to Fastener Notice in Service Precautions.
See: Brakes and Traction Control/Service Precautions/Vehicle Damage Warnings/Fastener Notice
See: Brakes and Traction Control/Service Precautions/Vehicle Damage Warnings/Fastener Notice
2. Install the screws to the EBCM (2).
Tighten the screws to 5 Nm (44 inch lbs.) in an X-pattern.