Express 3/4 Ton Van V8-5.7L VIN R (1998)
-
Tighten the three bolts to 9 Nm (7 ft. lbs.).
9. Install the EHCU to the vehicle frame.
-
Tighten the three bolts to 12 Nm (9 ft. lbs.).
10. Install the right front, left front and rear brake pipes to the tube adapters.
-
Tighten the three brake pipe fittings to 30 Nm (22 ft. lbs.).
11. Install the front and rear brake pipes (from master cylinder) to the combination valve.
-
Tighten the three brake pipe fittings to 30 Nm (22 ft. lbs.).
12. Connect the electrical connector to the combination valve.
13. Connect the four electrical connectors to the EBCM.
14. Install the EHCU Shield.
-
Tighten the three bolts to 12 Nm (8 ft. lbs.).
15. Lower the vehicle
16. Connect the negative battery cable.
17. Bleed the brake system. Refer to ABS Bleed Procedure.
IMPORTANT: Verify that the combination valve metering rod is depressed during bleeding.
18. Return to Diagnostic System Check. Refer to Diagnostic System Check.
