Express 3/4 Ton Van V8-5.7L VIN R (1998)
Brake Hose/Line: Service and Repair
Pipe Replacement (Master Cylinder to EBCM)
REMOVAL PROCEDURE
CAUTION: Always use double-walled steel brake pipe when replacing brake pipes. The use of any other pipe is not recommended and may cause
brake system failure. Carefully route and retain replacement brake pipes. Always use the correct fasteners and in the original location for replacement
brake pipes. Failure to properly route and retain brake pipes may cause damage to the brake pipes and brake system failure.
IMPORTANT: Brake pipes that run parallel to each other must maintain a 6 mm (1/4 in) clearance.
1. Disconnect the brake pipe(s) from the brake master cylinder.
2. Disconnect the rear brake pipe and/or the front brake pipe from the EBCM unit.
3. Remove the brake pipe retaining clips from the frame.
4. Remove the brake pipe from the vehicle.
INSTALLATION PROCEDURE
