Express 3/4 Ton Van V8-5.7L VIN R (1998)
7. Connect the Exhaust Gas Recirculation (EGR) pipe to the bracket and the front of the intake manifold.
8. Install the ignition coil and the ICM bracket.
9. Install the accelerator control cable bracket to the throttle body.
10. Install the accelerator control cable and the cruise control cable, it equipped, to the throttle shaft.
11. Install the fuel pipes to the rear of the engine.
12. Install the distributor to the engine.
13. Install the PCV at intake manifold using a twisting motion in order to lock.
14. Install the vacuum brake booster hose, if equipped.
15. Connect the following electrical connectors.
-
SCPI injector electrical connector.
-
Manifold Absolute Pressure (MAP) sensor
-
Canister purge solenoid
-
Idle Air Control (IAC) motor
-
Throttle Position (TP) sensor
-
Exhaust Gas Recirculation (EGR) valve
-
Engine Coolant Temperature (ECT) sensor
16. Install the coolant reservoir.
17. Install the engine cover..
18. Install the air cleaner assembly.
19. Fill the engine with coolant.
20. Connect the battery negative cable.
