Express 3500 V8-6.0L (2010)
2. Install new EBCM bolts (1).
Tighten the bolts in a cross pattern to 3 Nm (27 lb in).
3. Connect the electrical connector to the EBCM.
4. Install the brake modulator shield and the mounting nuts, if equipped, and tighten to 25 Nm (18 lb ft).
5. Install the brake modulator shield mounting bolt and tighten to 25 Nm (18 lb ft).
6. Lower the vehicle.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
8. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for programming and setup information.
