chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Front Seat Back Hinge and Recliner Mechanism Replacement|Page 12026 > < Power Seat Switch|Locations|Page 12021
Page 1
background image

Seat Back: Service and Repair
Front Seat Back Hinge and Recliner Mechanism Replacement

Front Seat Back Hinge and Recliner Mechanism Replacement

Removal Procedure

The front seat back recliner mechanism is mounted to the inboard side of the seat. 

1. Remove the seat from the vehicle. Refer to Driver or Passenger Seat Replacement   (See: Service and Repair/Driver or Passenger Seat

Replacement).

2. If removing the recliner mechanism remove the seat back recliner handle. Refer to Driver or Passenger Seat Recliner Handle Replacement   (See:

Service and Repair/Driver or Passenger Seat Recliner Handle Replacement).

3. Remove the seat cushion cover enough to access the bolts that retain the hinge or recliner mechanism (6) to the seat cushion frame. Refer to Front

Seat Cushion Cover and Pad Replacement   (See: Seat Cushion/Service and Repair/Front Seat Cushion Cover and Pad Replacement). 

4. Remove the seat back cover enough to access the bolts (2, 8) that retain the hinge or recliner mechanism to the seat back. Refer to Driver or

Passenger Seat Back Cushion Cover and Pad Replacement   (See: Driver or Passenger Seat Back Cushion Cover and Pad Replacement). 

5. Disconnect cable to seat Recliner.
6. Remove the bolts (2, 8) that retain the hinge/recliner mechanism to the seat back frame.
7. Remove the bolts (3, 7) that retain the hinge/recliner mechanism to the seat cushion frame.
8. Remove the hinge/recliner mechanism from the seat assembly.

Installation Procedure

1. Position the hinge/recliner mechanism  (6) to the seat assembly.

Caution:  Refer to Fastener Caution   (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).

2. Install the bolts (2,8) to retain the hinge/recliner mechanism (6) to the seat back frame and tighten to 32 Nm (24 lb ft).
3. Install the bolts (3,7) to retain the hinge/recliner mechanism (6) to the seat cushion frame and tighten to 32 Nm (24 lb ft).
4. Connect the seat cable to the recliner.
5. Install the front seat back cover. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement   (See: Driver or Passenger Seat

Back Cushion Cover and Pad Replacement). 

Front Seat Back Hinge and Recliner Mechanism Replacement|Page 12026 > < Power Seat Switch|Locations|Page 12021