Express 4500 V8-6.0L (2010)
1. Install the spacer block and the wheel speed sensor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the wheel speed sensor retaining bolt and tighten to 14 Nm (124 lb in).
3. Connect the electrical connector.
4. For the left rear sensor, install the leaf spring anchor plate. Refer to Leaf Spring Replacement (1500/3500) (See: Steering and
Suspension/Suspension/Suspension Spring ( Coil / Leaf )/Service and Repair/Leaf Spring Replacement)Leaf Spring Replacement (4500 Series) (
See: Steering and Suspension/Suspension/Suspension Spring ( Coil / Leaf )/Service and Repair/Leaf Spring Replacement).
5. Lower the vehicle.
6. Perform a low speed test to ensure the wheel speed sensor is functioning properly:
1. Start the engine and allow it to idle.
2. Check to see if the ABS indicator or the traction assist indicator remains illuminated.
3. If the ABS indicator or the traction assist indicator remains illuminated, DO NOT proceed to drive the vehicle until it is diagnosed and
repaired. Check the wheel speed sensor electrical connector to ensure it is not damaged and is installed properly. If the lamp remains
illuminated, refer to Diagnostic Starting Point - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic
Starting Point - Vehicle).
4. Select a smooth, dry, clean, and level road or large lot that is as free of traffic and obstacles as possible.
5. Drive the vehicle and maintain a speed of at least 16 km/h (10 mph) for at least 5 seconds.
6. Stop the vehicle and check to see if the ABS indicator or the traction assist indicator is illuminated.
7. If an indicator is illuminated, refer to Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnostic System Check - Vehicle).
