Express 4500 V8-6.0L (2010)
1. Position a NEW rear oil seal housing gasket (3) and the housing (2) to the engine.
2. Install the rear oil seal housing bolts (1) until snug. Do not overtighten.
3. Rotate the crankshaft until 2 opposing flywheel bolts holes are parallel to the oil pan surface.
Note: The tapered legs of the alignment tool must enter the rear cover oil seal bore.
4. Install the J-41476 - tool and bolts onto the rear of the crankshaft.
5. Tighten the J-41476 - tool bolts until snug. Do not overtighten.
6. Install the oil pan-to-rear oil seal housing bolts (1).
1. Tighten the oil pan-to-rear cover bolts to 12 Nm (106 lb in).
2. Tighten the rear oil seal housing-to-engine bolts to 30 Nm (22 lb ft).
7. Remove the J-41476 - tool.
