Express 4500 V8-6.0L (2010)
9. Position the small end of the seal (8) over the mating groove in the wheel drive shaft bar.
10. Compress the small clamp using the J 43218 or equivalent, until dimension (A) is 0.5-1.6 mm (0.02-0.06 in).
11. Vent the joint to relieve excess trapped air.
12. Compress the large clamp using the J 43218 or equivalent, until dimension (A) is 0.5-1.6 mm (0.02-0.06 in).
13. Install the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (See: Service and Repair).