Express 4500 V8-6.0L (2010)
6. Position the seal behind the joint face.
7. Wipe the grease from the face of the joint inner race, cage, balls, etc.
8. Remove the outer joint from the wheel drive shaft bar.
1. Have an assistant hold the joint housing.
2. Position a wood block between the seal and the joint (along the joint face).
3. Strike the wood block with a hammer to compress the axle shaft retaining ring.
4. Continue to strike the wood block to remove the outer joint from the wheel drive shaft bar.
9. Remove the retaining ring from the wheel drive shaft bar.
10. Remove the seal from the wheel drive shaft bar.
Installation Procedure
