Express 4500 V8-6.0L (2010)
4. Disconnect the outer tie rod from the steering knuckle using the J 24319-B.
5. Loosen the jam nut (2) and remove the outer tie rod (1) from the inner tie rod (3).
6. Inspect the shaft for bent or damaged threads.
7. Clean the tapered surface of the steering knuckle.
Installation Procedure
1. Lubricate the inner tie rod (3) threads with a suitable chassis lubricant before installing the outer tie rod (1).
2. Install the outer tie rod (1) to the inner tie rod (3). Do not tighten jam nut at this time.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the outer tie rod to steering knuckle retaining nut and tighten to 63 Nm (47 lb ft).
4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
