G 10 Van V8-305 5.0L VIN M SFI (1996)
Steering Linkage
INSTALL OR CONNECT
TOOLS REQUIRED:
^
J 29193 Steering Linkage Installer (12 mm)
^
J 29194 Steering Linkage Installer (14 mm)
NOTICE: If a clamp-type pitman arm is used, spread the pitman arm just enough with a wedge to slip the arm onto the pitman shaft. Do not spread the
pitman arm more than required to slip over the pitman shaft with hand pressure. Do not hammer damage to the steering gear may result.
1. Pitman arm (5) on the pitman shaft. Line up the marks made at removal.
2. Pitman arm washer and nut.
TIGHTEN
^
Pitman arm nut to 250 Nm (184 lbs. ft.).
Seating Ball Stud Tapers
3. Relay rod (2) or connecting rod (8) to the pitman arm ball stud. Make certain the seal is on the stud. Tighten J 29193 or J 29194 to 54 Nm (40 ft.
lbs) to seat the tapers. Remove the tool.
4. Relay rod nut or the connecting rod castellated nut.
TIGHTEN
