G 10 Van V8-350 57L Wiper Switch Service and Repair (1985)
3. Disassemble steering column as necessary to remove lock housing.
4. Remove base plate, turn signal switch, ignition lock, dimmer switch, as necessary.
5. Remove the switch retaining pin and the switch.
INSTALL OR CONNECTOR
1. Install the switch retaining pin and the switch.
2. Install base plate, turn signal switch, ignition lock, dimmer switch, as necessary.
3. Assemble steering column as necessary to remove lock housing.
4. Reinstall the turn signal/cruise control lever into the detent retaining clip inside the steering column.
5. Reconnect the turn signal/cruise control harness connector at the bottom of the steering column.
Multi-Function Lever Replacement
Typical Image Shown For Illustrative Purposes Only (w/standard column).
Typical Image Shown For Illustrative Purposes Only (w/Tilt column).
NOTE: The engagement switch, mounted on the turn signal lever, cannot be serviced. The complete turn signal lever must be removed as an assembly.
If the pull-wire breaks or the wire cannot be removed, it will be necessary to disassemble the steering column to string the wire harness.
REMOVE OR DISASSEMBLE
1. Disconnect battery ground cable.
2. Remove steering column lower cover and remove protective cover (26) securing wire to column.
3. Disconnect cruise control switch connector and attach a suitable piece of wire to switch connector.
4. Remove turn signal lever by pulling it out of the detent retaining clip inside the steering column. On some models, it may be necessary to
remove steering wheel and lock cover to guide the wire through the column.
5. Pull harness up gently so guide wire can be used to install new unit.
INSTALL OR CONNECT
1. Connect the new harness to the guide wire.
2. Place tape over the connector to make it easier to pull through the steering column.
3. Install the turn signal lever into the detent retaining clip inside the steering column.
4. Disconnect the guide wire from the cruise control switch connector and reconnect.
5. Install protective cover (26) around the cruise control switch harness.
6. Reinstall steering column lower cover.
7. Reconnect battery ground cable.
