G 1500 1/2 Ton Van V6-4.3L VIN W (1997)
NOTE: Clean gasket and knuckle surfaces thoroughly with a dry cloth.
INSTALL OR CONNECT
1. Splash shield gasket.
2. Wheel speed sensor and splash shield.
3. Two splash shield mounting bolts.
^
Tighten splash shield bolts to 16 Nm (12 ft. lbs.).
4. Two wheel speed sensor mounting bolts.
^
Tighten wheel speed sensor mounting bolts to 26 Nm (23 ft. lbs.)
5. Wheel speed sensor harness clip 3/16 rivet.
6. Harness clips to the wheel speed sensor wire.
^
Locate the clip directly centered over the white paint mark on the wheel speed sensor wire.
7. Harness clip at ball joint.
^
Tighten nut to 18 Nm (13 ft. lbs.).
8. Harness snap-in clip at upper control arm (light duty only).
9. Harness clip at shock tower.
^
Tighten bolt to 15 Nm (11 ft. lbs.).
10. Wheel speed sensor electrical connector.
11. Hub and rotor.
12. Brake caliper.
13. Install the tire and wheel.