G 1500 1/2 Ton Van V6-4.3L VIN W (1997)
Seals and Gaskets: Service and Repair
^
Tools Required:
-
J 2619-01 Slide Hammer with Adapter
-
J 23689 Axle Shaft Bearing Remover (large shaft)
-
J 29712 Axle Shaft Bearing Remover (9 1/2 inch ring gear)
-
J 8092 Driver Handle
-
J 21128 Axle Shaft and Pinion Oil Seal Installer
-
J 23690 Axle Shaft Bearing Installer
-
J 29709 Axle Shaft Bearing Installer (9 1/2 inch ring gear)
-
J 29713 Axle Shaft Seal Installer (9 1/2 inch ring gear)
Important: The driveline components in this vehicle have been factory system balanced. System balance provides a smoother running driveline
operation. However, it is essential that the positions of all driveline components relative to the propeller shaft and axles be observed and accurately
reference marked prior to disassembly. These components include the propeller shafts, drive axles, pinion flanges, output shafts, etc. All components
must be reassembled in the exact relationship to each other as they were when removed. Specifications and torque values, as well as any measurements
made prior to disassembly, must-be followed to maintain the factory balance.
Removing The Pinion Shaft Lock Bolt
Removing And Installing The Pinion Shaft