G 20 Van V8-379 6.2L DSL VIN C FI (1992)
3.
Remove the mounting nut from the power antenna mast (Figure 1, Item 5).
4.
Remove the mounting wedge from the power antenna mast (Figure 1, Item 6).
5.
Remove the finial from the top of the 100 rod of the power antenna mast (Figure 1, Item 1). (Keep the 100 rod from turning by gripping the rod
with pliers padded with a cloth to prevent damage to the rod surface, be careful not to bend the 100 rod.)
6.
Remove the insulator stop from the power antenna mast by sliding a 1 4mm deep well socket over the tube assembly (Figure 1, Item 7).
7.
Remove the 200/300 tube assembly from the antenna mast, by sliding them over the 100 rod.
MAST SECTION INSTALLATION
1.
Lubricate the contractor fingers of the new 300 tube with the supplied lubricant.
2.
Slide the assembly tool over the tube assemblies to compress the contractor fingers (Figure 2).
3.
Slide the assembly tool and mast assemblies over the 100 rod and into the stationary tube. (Make sure the fingers are inside the stationary tube.)
4.
Remove the assembly tool. then bottom the mast in the stationary tube. Make sure the threaded top of the 100 rod is above the top of the 200 tube.
5.
Install the new insulator stop by sliding it over the tube assemblies and secure using a 14 mm deep well socket.
6.
Install the mounting wedge.
7.
Install the mounting nut.
8.
Install the new finial.
9.
Reconnect the negative battery cable.
10.
Check cycle for proper operation.
Parts Information
Parts are currently available from GMSPO.
