G 2500 3/4 Ton Van V8-305 5.0L VIN M SFI (1997)
CAUTION:
^
Do not pry on the EBCM or BPMV with a mechanical aid. Excessive force will cause damage to the EBCM.
^
Do not reuse the EBCM gasket or mounting bolts. Always install a new gasket and mounting bolts with the replacement EBCM.
INSTALL OR CONNECT
1. New EBCM gasket onto BPMV.
CAUTION: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
2. EBCM to BPMV.
3. Gasket and insure correct alignment.
4. Four new EBCM bolts.
^
Tighten Four bolts to 5 Nm (39 inch lbs.) in an X pattern.
5. Four EBCM electrical connectors.
6. EHCU shield.
7. Three EHCU shield bolts.
^
Tighten three bolts to 12 Nm (8 ft. lbs.)
8. Lower vehicle.
9. Negative battery cable.
10. Revise tire calibration using Scan Tool and check for Diagnostic Trouble Codes (DTC)s. See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Testing and Inspection
