G 2500 3/4 Ton Van V8-305 5.0L VIN M SFI (1997)
11.
Install the new splash shield, P/N 15183966, as shown. Ensure that the shield is properly snapped into position.
12.
Connect the VCM/PCM harness connectors.
13.
Insert the VCM/PCM into the bracket.
14.
Install the retaining springs over the edges of the VCM/PCM.
15.
Install the air cleaner assembly.
16.
If a new VCM/PCM is being installed, program the VCM/PCM. Refer to VCM/PCM Reprogramming in the Engine Controls sub-section of the
Service Manual.
17.
Close the hood.
For 2000-2002 vehicles built prior to December 2001:
Install the new engine wiring harness deflector, P/N 15091839, road splash shield, P/N 15183966.
1.
Open the hood.
2.
Remove the engine wiring harness deflector from the left front fender and discard.
3.
Install the new engine wiring harness deflector. The new deflector attaches using only the front clip.
4.
Remove the air cleaner assembly.
5.
Disconnect the negative battery cable.
6.
Remove the spring retainers off the edges of the VCM/PCM.
7.
Slide the VCM/PCM out of the bracket.
8.
Disconnect the VCM/PCM harness connectors.
9.
Remove the nuts and the VCM/PCM mounting bracket.
10.
Install the new splash shield, P/N 15183966, as shown below. Ensure that the shield is properly snapped into position.
11.
Connect the VCM/PCM harness connectors.
12.
Insert the VCM/PCM into the bracket.
13.
Install the retaining springs over the edges of the VCM/PCM.
14.
Install the air cleaner assembly.
15.
If a new VCM/PCM is being installed, program the VCM/PCM. Refer to VCM/PCM Reprogramming in the Engine Controls sub-section of the
Service Manual.
16.
Close the hood.
