G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1997)
3. The brake pipe to the Electronic Brake Control Module (EBCM) unit.
^
Tighten the front brake pipe to the EBCM unit to 20 Nm (15 ft. lbs.).
4. The brake pipe to the front brake hose.
^
Tighten the front brake pipe to the front brake hose to 20 Nm (15 ft. lbs.).
5. Bleed the brake hydraulic system. See: Service and Repair
Rear Brake Front Pipe
WARNING: Always use double-walled steel brake pipe when replacing brake pipes. The use of any other pipe is not recommended and may
cause brake system failure. Carefully route and retain replacement brake pipes. Always use the correct fasteners and the original location for
replacement brake pipes. Failure to properly route and retain brake pipes may cause damage to the brake pipes and brake system failure.
Brake pipes that run parallel to each other must maintain a 6 mm (1/4 inch) clearance.
REMOVE OR DISCONNECT
1. The brake pipe from the Electronic Brake Control Module (EBCM) unit.
2. The brake pipe from the rear brake hose.
3. The brake pipe retainers from the frame.
4. The brake pipe from the vehicle.
