G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1997)
8 1/2 And 9 1/2 Inch Ring Gear
3. The rear brake pipes or axle from the brake hose.
4. The rear brake hose retaining bolt and bracket from the rear axle.
5. The brake hose from the vehicle.
INSTALL OR CONNECT
1. The brake hose to the vehicle.
2. The rear brake pipes on axle to the brake hose.
^
Tighten the rear axle brake pipes to the brake hose to 17 Nm (13 ft. lbs.).
3. The rear brake hose retaining bolt and bracket to the rear axle.
^
Tighten the rear brake hose retaining bolt to 17 Nm (13 ft. lbs.).
4. The retaining nut and retaining clip to the front brake hose.
5. The rear brake pipe to the brake hose.
CAUTION: The hose must not be twisted of contact any suspension components after installation.
6. Bleed the brakes. See: Service and Repair
Rear Brake Rear Pipe
