G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1997)
1.
Install the upper crankshaft bearing inserts to the block.
2.
Install the lower crankshaft bearing inserts to the crankshaft bearing caps.
3.
Apply engine oil to the crankshaft bearing inner surfaces.
4.
Install the crankshaft.
5.
Apply a 1/8 inch bead of gasket maker, GM P/N 1052942, or equivalent, on each side of the rear crankshaft bearing cap area.
Important:
Crankshaft bearing cap bolt sizes are as follows:
-
All inner crankshaft bearing cap bolts on crankshaft bearing 1, 2, 3, 4 and 5 are 12 mm (101 mm long) bolts.
-
All outer crankshaft bearing cap bolts on crankshaft bearing caps 1 and 5 are 12 mm (68 mm long) bolts.
