G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1997)
Timing Chain: Testing and Inspection
-
Tools Required
-
J 7872 Magnetic Base Dial Indicator, Or Equivalent
1. Mount the magnetic base dial indicator to the front of the block.
2. Position the dial indicator so that the plunger contacts the timing chain between the two sprockets.
3. Pull the chain outward, parallel to the front face of the block, to the maximum amount, with finger pressure on the inside of the chain.
4. Set the magnetic base dial indicator to zero.
5. Move the chain inward, parallel to the front face of the block, to the maximum amount with finger pressure on the outside of the chain.
6. Note the total indicator travel.
-
With used parts, the deflection must not exceed 20.3 mm (0.80 inch).
-
If the deflection exceeds this limit, inspect the sprockets and the timing chain for wear and replace the worn parts.
-
With new parts, the deflection must not exceed 12.7 mm (0.50 inch).
