G 30 Van V8-379 6.2L DSL VIN C FI (1992)
Fully engage the knurled tangs of Seal Remover-Installer J 23128-A into the recessed portion of the Seal by turning the handle clockwise. Remove
the Seal from the compressor with a rotary-pulling motion. Discard the Seal. The handle must be hand-tightened securely. Do not use a wrench or
plier (Fig. 28).
7. Remove and discard the seal seat O-ring from the compressor, neck using O-ring Remover J 9553-1.
8. Recheck the shaft and inside of the compressor neck and O-ring groove for dirt or foreign material and be sure these areas are perfectly clean
before installing new parts.