G 30 Van V8-6.5L DSL Turbo VIN F (1996)
Accelerator Pedal Position Sensor: Service and Repair
APP Module And Mounting Bolts
REMOVAL PROCEDURE
1. Disconnect the negative battery cable. Refer to Battery Disconnect Caution. See: Computers and Control Systems/Service Precautions/Vehicle
Damage Warnings
2. Disconnect the electrical connector.
3. Remove the mounting bolts (3).
4. Remove the sensor (2).
INSTALLATION PROCEDURE
1. Install the sensor (2) and the mounting bolts (3).
Tighten
^
Tighten the mounting bolts to 1 Nm (10 lb. in.).
2. Connect the electrical connector.
3. Connect the negative battery cable.
