G 3500 1 Ton Van V8-5.7L VIN R (1997)
3. Adjust the toe by turning the steering linkage tie rod adjuster to achieve the proper toe specification.
4. Verify that the toe adjustment is within specifications. Refer to "Caster, Camber and Toe Specifications."
Frame Bracket Knockout Removal
^
Tools Required:
-
J 38794 Knockout Removal Tool
Remove or Disconnect
1. Raise and support the vehicle.
2. The support the lower control arms with a suitable jack stand.
Important: The safety stands must remain under the lower control arms during the removal and installation in order to retain the lower control
arm position.
3. The tire and wheel from the vehicle.
4. The upper control arm from the frame bracket.
5. The knockout tool using J 38794.
-
The forward bracket requires the bridge to be installed between the legs of the bracket due to access problems.
-
Apply extreme pressure lubricant to the threads of the t-bolt and insert the bolt through the knockout hole in the bracket support.
6. Assemble the bridge, bearing (chamfered side out), washer, and nut in order.
7. The t-bolt head and bridge must line up horizontally with the knockout. The bridge should span the knockout without interfering with the knockout
procedure.
